IMR-E / Foil Feeding Device For In-Mold System

This is the device of setting foils for in-mold systems.

IMR-E / Foil Feeding Device For In-Mold System

Feature

Introduction of optical fiber sensor

Possible for detecting a pale color of register mark

Time of positioning: 2 seconds only

Using for short cycle time of electromotive injection molding machine

The specification of IMR-E series

  IMR
Model No. 250E 300E 400G
Width of foil Max. 250mm 300m 400m
Min 50mm
Paper tube diameter and outside diameter of foil 3 inches paper tube max.φ300mm
Positioning mark Lightproof or permeable register mark
(designation of shape, size, color)
Positioning system Optical fiber sensor
Positioning drive system Vertical feeding AC servo motor
Upper right and left AC servo motor
Lower right and left AC servo motor
Precision of foil feeding positioning ±0.045
Positioning time 2 seconds (foil feeding pitch:200mm)
Means of attachment for molding machine By an exclusive attachment flame
Connection with molding machine Full automatic interlocking operation by completion signal of ejector prominence or foil feeding
Metal mold thickness Movable side 130-220mm
Fixed side 180mm over
Roll wind (upper) Adjustment (back/forth) 65~230mm(from the surface of flame)
Adjustment (right/left) ±10mm (automatic)
Roll wind (lower) Adjustment (back/forth) 120~230mm (from the surface of flame)
Adjustment (right/left) ±10mm (automatic)
Max dimension of winding foil precipitation 260mm
Air source Air pressure (0.5-0.7MPa) 0.083Nl/cycle
Power supply 3 phase 200-230V ±10% 50/60Hz 1kVA
Machine dimensions Width 620mm 670mm 720mm
Depth × height 660×1900mm (fluctuation by machine)
With stand W800×D800mm
H 2200mm (fluctuation by machin)
Stand dimension 800×800×1300mm
Machin weight Machine abt 190kgf abt 210kgf abt 230kgf
With stand abt 290kgf abt 310kgf abt 330kgf